PRODUCT DESCRIPTION Universal strong two-component adhesive for repairing metal, pottery, porcelain, glass, pearls, precious stones and various synthetics. Temperature resistant, water resistant, chemical resistant and paintable. FIELD OF APPLICATION Suitable for repairs to metal, ceramics, porcelain, crystal, glass, pearls, precious stones and various synthetics (polyester, Bakelite, Formica, rigid polystyrene and acrylic glass (Perspex). Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber. PROPERTIES • Super-strong (up to 170 kg/cm²) · Resistant to temperatures between -40 °C and +100 °C · Filling · Water resistant · Chemical resistant · Paintable PREPARATION Working Conditions: Only apply at temperatures between +10 °C and +35 °C. Product cures by mixing the resin and the hardener. Personal safety: Preferably wear gloves. Surface Requirements: The surface must be dry, clean and free of dust and grease. Preliminary Surface Treatment: Degrease parts to be bonded with methylate spirit. Roughen smooth surfaces (sandpaper). Tools: Mix the components by means of the supplied mixing bowl and spatula. APPLICATION Coverage: 1 ml = approx 10 cm² at a film thickness of 1 mm Directions for use: Press out an equal amount of both components onto the enclosed mixing tray. Mix these two equal parts well with a spatula until a mixture is obtained with a homogeneous color. Apply the mixture, which at room temperature (+20 °C) remains tool able for about 1.5 hours, as a thin layer on one of the two materials. Join the materials and keep them in place for 7 hours. Be careful not to move the parts before the adhesive has cured. Resin and hardener must not come into contact with each other unless for usage. Stains/residue: Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically. Advice: Some types of synthetics can’t be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing. Points of attention: Close well after use. For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Adhesive does not cure below +5 °C.
Bonding technique: 1-Sided application Chemical base: Epoxy resin Chemicals resistance: Water, oil, grease, solvents, diluted acids and alkalis Color: Opaque, honey colored Consistency: Liquid Density approx.: 1,1 g/cm³ Filling capacity: Very good Final bond strength (Alu): 19 N/mm² Final bond strength after: 24 hours Handling time: 6 hours Minimum temperature resistance: -40 °C Maximum temperature resistance: 100 °C Moisture resistance: Good Mixture ratio: 1:1 Paintability: Yes Potlife: 90 minutes Solvent free: Yes UV resistance: Very good Viscosity: Medium viscosity Viscosity approx.: 35000 mPa·s Water resistance: Good Water soluble: No STORAGE CONDITIONS Store tightly closed in cool and dry place.
